Small, nimble and cunning to boot. Sarcos often end up straying to the darker side of dealings. renowned as grifters, con men, hustlers, thieves. Organized crime comes as naturally to them, as dodgy counterfeit coins come to people who trade with them. Whether a natural ability or a social trait they always know when its time to cut and run.
Ahoy there everyone and welcome back to another of our weekly dev posts! It’s been a big week this week with the launch of the new Faith & Flintlocks site and we’re super stoked with how it has turned out. Jono did a fantastic job organizing our mess of ideas into something cohesive and snazzy. … More Weekly Update #268
Ahoy there dear readers and welcome back! I hope you’ve all had a good week or at least continued to survive the dumpster fire of 2020 😀 As for us we’ve actually had quite a productive week. We’ve been through and tidied up some more of the fluff and marketing for the new website. The … More Weekly Update #261
Ahoy there dear readers! Nice to see you all back here after another week of madness. Hopefully you’re all surviving and thriving out there. As for us, well Simon has been busy with life which has meant he’s been out of commission most of this week. Jono has been working on the website and cards. … More Weekly Update #257
AAaaaand we are back! Ahoy there dear readers. Apologies for the lack of a post last week but I was all but dead from work so it just wasn’t going to happen. But this week, well that’s a different story. I’ve done a test print of my cheat sheet, which I quickly found lacking! I’ve … More Weekly Update #213
Ahoy there dear readers! Welcome back to what is most likely our last post for the year. Simon and I will shortly be heading on holiday and we’re looking forward to some boardgames, x-wing and play testing Faith & Flintlocks in between snoozing and relaxing. So as a nice little last hurrah for the year … More Weekly Update #188
Hello again one and all. This week we’ve been busy with 3d prints and 3d sculpts. Diving into the week that was: The Sarcos has had a reprint on the 3d printer and has come up very nicely. The detail is a bit sharper and crisper, which means there shouldn’t be any tweaks till after … More Weekly Update #150
Something went wrong. Please refresh the page and/or try again.